Vision Blew Over
I have a 1989 Hydrostream Vision Canadian edition, with a 90
hp V4 Evinrude, The Boat blew over in a bad storm and caused the bottom
fin on the lower unit to bend. The bottom end, Motor and Transom all seem
ok But I am just wondering if I should worry about this at all and if
there are any problems with this how would I fix it ? Also I bought the
boat late in the season and have not had it on the water, what should I
expect for numbers? I was hoping at least high 40's low 50's MPH is this
speeds are realistic. You will have to apply heat to the skeg to bend it
back. Be careful and go slowly, not trying to bend
it back all at once.
Please submit whatever questions you have to IHRTechTalk@yahoo.com. All questions and answers selected will be displayed on this page as they come in. Note: though all boaters are welcome, priority may be given to I.H.R. members. Randy can not be held responsible for any advice given. Though his information and expertise is second to none, he has no control over what you do with your boat. It is up to you to boat safely and act responsibly, and his advice is only to be used as a guidance for your high performance boat/motor of which you are the one responsible for the risks involved.
I.H.R. l History
Pictures l Feature
Article l Tech